01Specification
The specification arrives with the order. A hundred pages or more, and somewhere in it is the requirement that departs from your own standard.
Which protection rating does Meier’s specification require, and does it differ from our standard?
In section 3.4, the specification requires protection rating IP65 for all control cabinets in the field 1. Your design guideline specifies IP54 2. On the 2023 project, the same deviation was resolved with a special release. The engineering email names the extra effort 3.
- 1Meier specification · Rev. B
- 2Design guideline
- 3Email thread 2023
Deviations stand out before design work begins.
02Design and variants
A similar part has gone through production before. What took longer than planned back then is in the post-calculation and the meeting minutes.
Have we made a part like this before? And what went wrong back then?
Yes, in 2024 with a similar geometry 1. The post-costing shows the setup time ran twice as long as planned 2. The meeting minutes state the reason: the fixture had to be modified twice 3.
- 12024 order file
- 2Post-costing
- 3Meeting minutes
Planning starts with the experience of the last order. What went wrong once is known the next time.
03Changes and change orders
Requirements change during a project. Who requested and agreed to what, and when, is spread across emails, minutes and measurement records.
Which revision applies to control cabinet +S12, and what has changed since release?
Revision D from 4 June applies 1. Two changes have come in since release: an additional motor feeder at the customer’s request, requested by email on 27 May 2, and a larger main switch following the new load calculation 3.
- 1Change log
- 2Customer email thread
- 3Load calculation
Changes are documented in minutes. Change orders are easy to justify, discussions get shorter.
04Testing and records
Delivery comes with documentation. Certificates, cutting lists and delivery notes sit in different places.
The customer wants the 3.1 certificate for batch 84120. Where is it, and where did the rest of the bar go?
The EN 10204 inspection certificate is filed with the goods receipt from 12 May 1. The batch went into three orders, the cutting list shows dimensions and remaining length 2. The delivery note for the customer order lists position and quantity 3.
- 13.1 material certificate
- 2Cutting list
- 3Delivery note
Tracing a batch starts with a question, not a search.
05Commissioning
The plant is on site at the customer, and the deadline is close. A fault appears that has happened before.
During commissioning, the inverter on the conveyor shuts down on overtemperature. Have we seen this before?
Yes, in 2023 on an identical plant 1. The cause was an incorrectly set motor parameter, the commissioning report gives the correct value 2. The inverter manual describes the setting in section 7.3 3.
- 1Service report 2023
- 2Commissioning report
- 3Inverter manual
The fix from back then is found in minutes.
06Service and experience
A fault on a plant from 2014. The colleague who built it retired a year ago.
Why does the 2014 plant have a different busbar cross-section than the drawing shows?
There is a special release from the construction phase 1. The designer at the time justified the deviation by email 2. The as-built drawing shows the actual build, it never made it into the ERP 3.
- 1Special release 2014
- 2Engineering email
- 3As-built drawing
Experience that has left the building stays retrievable.